Shoreline Hot Tub Dokumentacja Pobierz pdf (Strona 15)

Page

7) Turn off the hose, and then verify there are no leaks at the pump unions during filling your hot

tub.

8) Reinstall the filter cartridge and basket into the filter canister.

TURNING THE POWER ON

WARNING: Do not turn on any pump until your hot tub is properly filled with water.

Running any pump without water in your hot tub can cause IMMEDIATE damage, which will not

be covered under warranty!

After filling your hot tub with water to a level of approximately 1" above the highest jet (or about

½" below the pillow), you can turn on the power to the hot tub at the main circuit breaker. Verify

that your hot tub has no error codes. If you encounter a problem, please refer to the

troubleshooting guide.

TESTING THE RCD BREAKER

Test the RCD breaker prior to first use and weekly thereafter when power to the hot tub is

turned on. To test the RCD breaker, please follow these instructions (hot tub should be

operating):

1) Press the "TEST" button on the RCD. The RCD will trip and the hot tub will shut off.

2) Reset the RCD breaker by switching the breaker to the full "OFF" position, wait a moment,

then turn the breaker back on. The hot tub should have power again.

DANGER -- RISK OF ELECTRICAL SHOCK: If the RCD breaker fails to operate as

described, there is a possibility of an electrical shock if the hot tub is used. Do not use the hot

tub. Turn off the power at the main electrical service panel until the source of the problem has

been identified and corrected by a licensed electrician or qualified hot tub technician.

PRIMING THE PUMPS

When power is turned on, your hot tub is automatically programmed to start circulating the

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Brak uwag

Shoreline Hot Tub Dokumentacja Strona 15